Transport Phenomena - Delft University of Technology

Sorted by YearSorted by First Author

A Combined Lossy Capacitor Population Balance Model (Lcpbm) for Calculating the Influence of Frequency on Electric Field Enhanced Coalescence in a Static-Mixer Settler Setup

A Combined Lossy Capacitor Population Balance Model (Lcpbm) for Calculating the Influence of Frequency on Electric Field Enhanced Coalescence in a Static-Mixer Settler Setup, Esayas W. Barega, Edwin Zondervan, and Andre B. de Haan. Chemical Engineering Science 2013, 104 , 727–741.

Download

[DOI] 

Abstract

In this work a combined lossy capacitor population balance model (LCPBM) is developed to predict the effect of a square wave frequency on electric field coalescence (drop size) in a static mixer settler setup for the caprolactam-toluene-water system. The static mixer is used to mix the organic and aqueous phases. The electric field is applied by placing insulated electrodes at the end of the static mixer. The electrical circuit model of the system is based on the lossy capacitor model where the insulation and the dispersion are considered as leaky dielectrics. The charge and the electric field are determined from the electrical circuit model and coupled in the hydrodynamic equation to calculate the velocities of drops. The velocities are in turn used in the population balance model (PBM) to determine the time evolution of the drop size. Three approaches are used to calculate the electrical force and the charge on the drops from the circuit model: (1) the Bailes' charge hypothesis where the drops pick their charge horn the free dispersion-insulation interfacial charge, and the electrical force calculated based On electrophoretic contribution, (2) the electrical force determined from the Taylor-Melcher leaky dielectric model considering the electrical force due to the free charge and the force due to the difference in dielectric permittivity's of the dispersion and insulation, and (3) by accounting for the free charge convection by the fluid motion which results in equal redistribution of the polarization charge between the dispersion and the insulation. The (LCPBM) model was validated by measuring drop sizes using a square wave 01 04 kV/cm and frequencies between 3 and 100 Hz for two flowrates. With all approaches, the mean sauter diameters were calculated within 10% relative error at lower frequencies for both flowrates. At higher frequencies of 50 Hz and 100 Hz, a 20% relative error was obtained for the first approach. A better prediction within 10% was found for the second and third approaches with the later approach giving the best prediction. (C) 2013 Elsevier Ltd. All rights reserved.

BibTeX

@article{ ISI:000327735900064,
Author = {Barega, Esayas W. and Zondervan, Edwin and de Haan, Andre B.},
Title = {A Combined Lossy Capacitor Population Balance Model (Lcpbm) for Calculating the Influence of Frequency on Electric Field Enhanced Coalescence in a Static-Mixer Settler Setup},
Journal = {Chemical Engineering Science},
Year = {2013},
Volume = {104},
Pages = {727-741},
Month = {},
Abstract = {In this work a combined lossy capacitor population balance model (LCPBM) is developed to predict the effect of a square wave frequency on electric field coalescence (drop size) in a static mixer settler setup for the caprolactam-toluene-water system. The static mixer is used to mix the organic and aqueous phases. The electric field is applied by placing insulated electrodes at the end of the static mixer. The electrical circuit model of the system is based on the lossy capacitor model where the insulation and the dispersion are considered as leaky dielectrics. The charge and the electric field are determined from the electrical circuit model and coupled in the hydrodynamic equation to calculate the velocities of drops. The velocities are in turn used in the population balance model (PBM) to determine the time evolution of the drop size. Three approaches are used to calculate the electrical force and the charge on the drops from the circuit model: (1) the Bailes' charge hypothesis where the drops pick their charge horn the free dispersion-insulation interfacial charge, and the electrical force calculated based On electrophoretic contribution, (2) the electrical force determined from the Taylor-Melcher leaky dielectric model considering the electrical force due to the free charge and the force due to the difference in dielectric permittivity's of the dispersion and insulation, and (3) by accounting for the free charge convection by the fluid motion which results in equal redistribution of the polarization charge between the dispersion and the insulation. The (LCPBM) model was validated by measuring drop sizes using a square wave 01 04 kV/cm and frequencies between 3 and 100 Hz for two flowrates. With all approaches, the mean sauter diameters were calculated within 10\% relative error at lower frequencies for both flowrates. At higher frequencies of 50 Hz and 100 Hz, a 20\% relative error was obtained for the first approach. A better prediction within 10\% was found for the second and third approaches with the later approach giving the best prediction. (C) 2013 Elsevier Ltd. All rights reserved.},
DOI = {10.1016/j.ces.2013.10.002},
ISSN = {0009-2509},
EISSN = {1873-4405},
Unique-ID = {ISI:000327735900064},
}

Generated by bib2html.pl (written by Patrick Riley ) on Fri Jul 28, 2017 13:53:02


Last modified: July 28 2017. © Delft University of Technology - TP group 2012